This shows you the differences between two versions of the page.
simple_melbus_emulator-_sme [2014/06/12 12:16] reinis |
simple_melbus_emulator-_sme [2018/03/17 16:03] (current) |
||
---|---|---|---|
Line 2: | Line 2: | ||
* DIN male plug connector as the main connector- for power, MELBUS and audio. | * DIN male plug connector as the main connector- for power, MELBUS and audio. | ||
* Atmega328p/Atmega168 as controller | * Atmega328p/Atmega168 as controller | ||
+ | * Linear voltage regulator | ||
* Stereo audio transformers for separate grounds | * Stereo audio transformers for separate grounds | ||
* 3.5mm jack socket | * 3.5mm jack socket | ||
* Powered by HU? Maybe a small connector for external power? Both? | * Powered by HU? Maybe a small connector for external power? Both? | ||
- | * 4 pin UART + reset connector, small ICSP connector to burn bootloader. | + | * 4 pin UART + reset connector, small ICSP connector (or just pads) to burn bootloader. |
* Break out the spare GPIOs to control Bluetooth module / connect external buttons. | * Break out the spare GPIOs to control Bluetooth module / connect external buttons. | ||
* SMD parts for low-height footprint- it should just plug into HU. | * SMD parts for low-height footprint- it should just plug into HU. | ||