User Tools
simple_melbus_emulator-_sme
Differences
This shows you the differences between two versions of the page.
|
simple_melbus_emulator-_sme [2014/06/12 12:16] reinis |
simple_melbus_emulator-_sme [2018/03/17 16:03] (current) |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| * DIN male plug connector as the main connector- for power, MELBUS and audio. | * DIN male plug connector as the main connector- for power, MELBUS and audio. | ||
| * Atmega328p/Atmega168 as controller | * Atmega328p/Atmega168 as controller | ||
| + | * Linear voltage regulator | ||
| * Stereo audio transformers for separate grounds | * Stereo audio transformers for separate grounds | ||
| * 3.5mm jack socket | * 3.5mm jack socket | ||
| * Powered by HU? Maybe a small connector for external power? Both? | * Powered by HU? Maybe a small connector for external power? Both? | ||
| - | * 4 pin UART + reset connector, small ICSP connector to burn bootloader. | + | * 4 pin UART + reset connector, small ICSP connector (or just pads) to burn bootloader. |
| * Break out the spare GPIOs to control Bluetooth module / connect external buttons. | * Break out the spare GPIOs to control Bluetooth module / connect external buttons. | ||
| * SMD parts for low-height footprint- it should just plug into HU. | * SMD parts for low-height footprint- it should just plug into HU. | ||
simple_melbus_emulator-_sme.1402564594.txt.gz ยท Last modified: 2018/03/17 16:03 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
